Reset Oil Light

Reset Oil Light 1

The reset oil light procedure is very simple and can be done in a matter of seconds. You will need to find the oil life sensor, which is located on the side of the engine block. Once you find it, simply press and hold the button for 5 seconds.

This will reset the oil light and allow you to continue driving without having to worry about it coming back on.

How to Reset the Change Engine Oil Light on your Car

The reset oil light procedure is simple and can be done in a matter of minutes. You will need to have your car parked on level ground, with the engine turned off and the keys out of the ignition. Once you have located the oil dipstick, wipe it clean with a rag and reinsert it.

Be sure to fully insert the dipstick so that you get an accurate reading. Now, turn the key to the “on” position without starting the engine. Allow all of the lights on your dash to come on for about 10 seconds before turning off again.

At this point, you can start your engine and allow it to idle for about 30 seconds while checking your oil level again with the dipstick. If everything looks good, you’re all set! If your car’s oil light comes on frequently or if you notice any leaking or low oil levels, be sure to take it in for service as soon as possible.

Ignoring these warning signs could lead to serious engine damage down the road.

Reset Oil Light

Credit: www.youtube.com

How Do I Reset My Oil Light

Assuming you would like tips on resetting your oil life monitor: Most cars made after the mid-2000s have an oil life monitor that keeps track of the engine’s oil quality and mileage. The purpose of this system is to notify drivers when it’s time for a change so that they can avoid damaging their engine with old, dirty oil.

If your check engine light is on, or you’re due for an oil change, you’ll need to reset the system. Here’s how: 1. Locate the oil life button.

This is usually located on the instrument panel near the odometer. 2. Press and hold the button until the display changes or blinks. This may take a few seconds.

3. If successful, a message will appear onscreen letting you know that the system has been reset. 4. Start up your car and drive as usual!

Conclusion

If your oil light is on, it means that your engine is not getting the proper lubrication it needs. This can be caused by several things, such as low oil levels, a dirty oil filter, or a problem with the oil pump. To reset the light, simply add more oil to the engine and/or clean the filter.

If the light does not go off after doing this, then there may be a more serious problem and you should take your car to a mechanic.

Please follow and like us:
Reset Oil Light 4
Pin Share

Leave a Reply

Your email address will not be published.

Pinterest
LinkedIn
Share
Instagram